Material01

First kerf Last kerf Increment

Kerf compensation, −1 to 1 mm. Negative values loosen the fit; positive values tighten it. Up to 15 pairs. The last value is included only if the increment reaches it.

Only the tab, notch, and mating shoulders are adjusted. Fit each matching pair flat, edge to edge. Choose the snug fit. Compensation is already applied; set extra kerf offset to zero.

Set the SVG’s “engrave-labels” group to a light line engraving before cutting the “cut-outlines” group. Labels use red hairlines (RGB 255, 0, 0); cut outlines use black hairlines.

Pattern Asanoha / Hemp leafTriangular latticeDiamond lattice

Panel dimensions and pattern are shared with Assembly.

Cells across width

Lattice width Frame width

Measured from the panel edge to the cutouts. Boundary spokes are included in this width.

Panel dimensions and pattern are shared with Pattern. Height excludes the legs; total height is panel height + leg height.

Material thickness Cut kerf Fingers per front / back edge

Bottom panel

Bottom clearance

mm

Bottom tabs per edge

tabs

Clearance is measured from the top of the legs to the underside of the bottom panel. Tabs fit closed wall slots; kerf compensation is included.

Legs

Leg height

mm

Leg width

mm

Two legs per wall, extending below the panel height.